Eggtimer Rocketry Flight Computer Manual de usuario

Eggfinder RX Assembly Manual RX Board Rev B4d © 2014 Eggtimer Rocketry All Rights Reserved

check to make sure that you have this inserted correctly! Turn over the board and solder the leads to the board. Trim the leads flush. ___ Mount t

__ With a permanent marker, write the RF module’s frequency on the board in the space provided next to the antenna (i.e. “915”). Eggfinder RX Ante

___ Measure 80 mm from the edge of the board, and mark the antenna wire there. ___ With a pair of sharp diagonal pliers, cut the wire at the 80mm

have confirmed that it’s working you can always go back and remove the cable and put a battery and Bluetooth®-Serial module in its place. Mounting t

your Eggfinder RX into a USB port on your laptop/tablet, the RED LED should immediately come on indicating that you have power. After one or two seco

compressed air to “blow away” excess solder. The resulting splatter will almost always cause more damage than the original solder bridge. Another th

Troubleshooting Tips (in approximate order of likelihood) RED PWR LED doesn’t come on • Cable wired incorrectly (RED wire should be on BATTERY

Installing a RP-SMA Connector for an External Antenna If you decide to install a RP-SMA connector for an external antenna on your Eggfinder RX board

California Proposition 65 Warning WARNING: This product contains chemicals (lead) known to the State of California to cause cancer and birth defects

Important Regulatory Information This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this d

Hope RF HM-TRP Documentation (FCC test documentation) http://www.hoperf.com/upload/rf/HM-TRP-915(20dBm)-FCC.pdf FAA Regulations for Amateur Rocketr

About Soldering Your Eggfinder… Assembling your Eggfinder isn’t that hard, but we recommend that you don’t choose it as your first kit project. Yo

General Assembly Information We’re sure that you are ready get started, but before you do you will need to get some tools together. The tools that y

Assembling your Eggfinder RX Board Step 1: Sort the Components Before you start soldering anything, you need to lay everything out and make sure t

Note that some of the components are static sensitive, so you should avoid sources of static electricity while you are handling them. We recommend

Eggfinder RX Assembly Checklist Before you solder anything, make absolutely sure that you have the correct part and that it is inserted in the board